TPG Community

Get online support

Using a third party router for NBN FTTP

Riezl
Moderator

We believe that the settings for Netgear D7000v1 and Netgear D7000v2 are almost the same.

 

Nonetheless, you need to make sure that the following settings are properly configured:

 

Multiplexing Method : LLC Based
VPI: 8
VCI: 35
Encapsulation : PPoE
Login: Your TPG Account Username
Password: Your TPG Account Password

 

You need to make sure that the TPG account details are correct. You can verify it by logging in to TPG My Account : https://www.tpg.com.au/home/myaccount

 

You may send us a screenshot of the modem's interface so we can double check.

GavinLong
Level 2

So I did a full factory reset, let the D7000v1 reboot and the Wizard took over, put my UN and PW in and it worked! Online with it now, Speedtest was great. 


I went to the Internet settings page and the multiplexing Method is now set to 'VC-Based', VPI8, VCI35, PPPoE, Dynamic IP, Auto DNS, NAT Enabled, Router MAC is Use Default Address, Transfer Mode is ADSL(ATM), DSL Mode is Auto. 

 

Go figure! 

Will
Moderator

That's wonderful news, @GavinLong!

 

I'm glad that you're able to set your router up and thanks for keeping us in the loop and providing the settings for others to possibly emulate.