TPG Community

Get online support

Archer VR1600v keeps rebooting whenever an external USB HDD is plugged in

jonwwhite
Level 2

Hello,

 

I received the TP-Link Archer VR1600v router when I had the NBN installed a few weeks ago. On the whole, it is functioning fine, except that when I plug our external USB HDD into it to enable the USB Sharing feature, the router keeps power cycling and rebooting every few minutes. It doesn't seem to do this same behaviour if I plug a normal USB thumb drive in

 

The HDD is a 3TB Seagate SRD00F2 with an external 12V power adapter, which is shared across our home network.

 

Is this a known problem, and is there likely to be a fix?

6 REPLIES 6
orbistat
Level 8

Hi @jonwwhite I have a feeling it may have a 2TB limit, I’ll check the specs and get back to you when I’ve checked. If so partitioning might work.

orbistat
Level 8

Hi @jonwwhite Ok from what I've been able to dechipher, the older TP-Link devices have a 2TB bios limit on external drives, you can have a maximum of 8 volumes, they need to be formatted in FAT32 or NTFS, the newer 'Archer' series products seem to be able to support 5TB with the 8 volume limit still applying, formatted in FAT32, NTFS and possibly supporting HFS+ in some cases, the specific models are not listed.

 

 What I'd be trying first is ensuring you have the latest firmware on your VR1600v which I beleive to be Firmware Version:0.1.0 0.9.1 v5006.0 Build 180828 Rel.56416n, also see if there's a firmware update for your seagate expansion drive on the Seagate support site, this will at least ensure that the hardware compatibility lists on both devices are as up to date as possible.

jonwwhite
Level 2

Hi Orbistat. Thanks for your help. I can confirm that my router has the latest firmware. I have just checked Seagate's site, and they don't have any newer firmware for my HDD, so I guess I'm probably out of luck.

Anonymous
Not applicable

Hi @jonwwhite,
 

Thanks for sharing this with us. Since the normal USB Flash drive works fine with TP-Link's USB Sharing Feature, have you tried @orbistat's suggestion to make partition to your HDD? I would love to know how it will go.

 

Cheers!

hungryben
Level 2

Might be a bit late but i split up my WD 5TB drive into 3 parts (2/2/1TB) roughly and my Archer VR1600 detected it as 3 drives successfully.

Thanks for the thread solution @orbistat 

orbistat
Level 8

@hungryben wrote:

Might be a bit late but i split up my WD 5TB drive into 3 parts (2/2/1TB) roughly and my Archer VR1600 detected it as 3 drives successfully.

Thanks for the thread solution @orbistat 


Thanks for posting your results @hungryben a good outcome, it also shows that it works the same on either hardware revision as I see you're on V2.