Just got a new router (Asus RT-AC86U AC 2900). I've been using a Netgear D6220 for about 2 years now without any trouble. I'm on FTTN NBN. I've been searching online for answers but still fail. I'll list what I have tried:   Removed Line/Phone Splitter (always) Updated Firmware: 3.0.0.4_384_82072-gc842320 Login type: PPPoE Automatic IP Normal DHCP Aggressive DHCP Continuous DHCP TPG login/pass: (login/pass) MTU/MRU: 1492 VLAN ID: Internet VID: 2 PRIO: 0 TPG (I also tried this)   I've done these in many combinations both before and after a factory reset as well as rebooting after applying new settings and got the same message everytime. "Network cable is unplugged" and the WAN light (2, refer to picture) stays red. I'm certain that the network cable is connected properly and to the correct port (10). I've read this thread and that was the best I could find.   Any help would be appreciated.       ... View more