Hi Basil, finally TPG sent me a new Router hoping it fix few issues with the connect (NBN drops me out every 3h). However I'm writing for another issue after that i spoke with TPG operator and they are not able to help, i'll be appreciated if you can help with that. I got a new router from TPG : VX420-G2h and because i live away from home the first think that i did was to enable the access to the remoter remote;y (using a service NO-IP) (SEE PHOTO3), basically i went in Advanced > SystemTools>Administration  and i enbled the option Remote Management insering the port number 8080 . It work good, when i'm away from home, i digiit myDomainName:8080 and i can access to the router (SEE PHOTO1) The problem is with the other devices that i tried to access. I tried to set up the cameras to by the  Nat Forwarding > Virtual Server adding each single service,ex.port,internal ip,internal port and both the protocol . When i diigit from external myDomainName:xxxx (xxxx is the external Port set in the virtual server), nothing happen . What is strange is that i just copy the parameter from the Archer1600 modem (everything works on this old modem). Only difference that i noted between the 2 router when i set the virtual server is that the new modem (VX420-G2H) has a list of ''Interface Name'  and i selected PPOE_PTM_2_1 (but i think it is irrilevant) (SEE PHOTO 3). I also tried to disable the FIREWALL on the router and on the computer that i'm using . Hoever what is strange is that i can access to the router but not to the other device ? Is it something that i should change on the router ?Any other idea ? Thanks for the help ... View more