TPG Community

peterpayne · ‎24-08-2024

Thanks David, the BE65 is hard red when trying to connect to PPoE. I can get it working in AP mode but not as Router connected to NBN Modem directly. I have spent 3 days with TP-Link support but no joy so far… they suggested asking TPG for newer version on NBN modem as mine quite old (5+ years) but TPG say NBN will not upgrade NBN modems… I was hoping someone on the forum might have managed to connect BE65 to NBN modem.

peterpayne · ‎24-08-2024

I am wanting to use the BE65 direct to the NBN modem , the same way I have the X20 set up and the same way that the original 1600 was set up Yes I have done the VLAN setup and using iP4 not 6

peterpayne · ‎24-08-2024

Hi. I have a TPG NBN HFC service and wanting to replace router with Deco BE65. Router was TP-Link Archer 1600v with PPPoE connection VLAN Id 2. This works with the NBN box. I have replaced this with a TP-Link Deco X20, PPPoE VLAN Id 2 etc … this works without any problems. I can switch back and forth quite happily between 1600v & X20 as router… PPPoE login etc no problem BUT want to replace TP-Link Deco x20 with TP-Link Deco BE65 and cannot get connection to PPPoE using the BE65???

TPG Community

About peterpayne

Re: NBN HFC with TP-Link Deco BE65 Problem

Re: NBN HFC with TP-Link Deco BE65 Problem

NBN HFC with TP-Link Deco BE65 Problem