Get online support
Hi @kieronagius,
We've detected a session with your service. Were you able to configure your D-Link Cobra with TPG NBN?
Regards,
BasilDV
Hi Basil,
I have managed to work through the issue on my DLINK Cobra DSL-5300. For my FTTC connection the settings below enabled my connection.
The process was to use the wizard to setup the internet connection
Step 1 VDSL - make sure to enable VLAN and enter 2 for the VLAN ID.
Step 2 Select the PPPoE connection type
Step 3 Enter the TPG supplied Username and Password
Step 4 Setup the WIFI Name and password.
Step 5 Setup Device Admin password
Then finish by selecting Next.
Next go to the Setting Menu and select Internet and then IPv4 sub-menu
Step 1 Change WAN Access Type to Residential Gateway
Step 2 Change My Internet Connection to PPPoE
Step 3 Then Save
On that same page Select the VLAN sub-menu
Step 1 Enable V-LAN
Step 2 Under Internet VLAN ID enter the value 2
Step 3 Under the IPTV VLAN ID enter the value (any other value other than 2)
Step 4 Under the VOIP VLAN ID enter the value (any other value other than 2 and the value you inputed in IPTV)
Step 5 Then Save
DLINK and TPG were a great support, so thanks.
Kieron
Wow! Thanks for the guide, @kieronagius.
I'm sure that others will be able use this as their reference.
Thank you so much for these instructions and settings. After a stressful few days we finally have our modem working. Thank you, thank you, thank you
Hi Basil
I have just bought a COBRA DSL 5300 and have followed the instructions outlined by keironagius yet still am unable to connect to the internet.
How best can i progress the investigation of this issue?
Thanks for your assistance
Vishen