We have a VDSL connection and would like to set the TP-Link Omada network up as per below. Archer VR1600v (to be used as DSL modem only) >TP-Link ER707-M2 (router DHCP) >TL-SL2428P (Switch) / Unifi POE Switch. There are also two EAP610-Outdoor plugged into the TL-SL2428P switch. Both switches are plugged into the gigabit LAN ports 4 & 5 on the TP-Link ER707-M2 router. I have plugged a network cable into the LAN port 1 of the VR1600 into the WAN port of the ER707 router, is this correct? I currently have the archer VR1600v set up in bridge mode (VLAN2) with DHCP disabled, i have then enabled DHCP and configured WAN settings on the TP-Link ER707-M2 router. The network & the internet seems to work until i reboot the VR1600v, once i do that it shows that it shows that it is in bridge mode and i lose internet. The error message i get in the ER707 is "PPoE failed to connect to the server because sending PADI timed out".    I spoke to TPG who told me i need to enter a password for the internet to connect however i did not need one in the VR1600 as it just had "noPassword", they also provided me with a different username to the one that was set in my VR1600. I tried all combinations they provided without success. Each time i just got the same error "PPoE failed to connect to the server because sending PADI timed out" In the screenshots attched you can see the dashboard doesn't show the gateway which also makes me think something is wrong. Any help or advice would be greatly appreciated. ... View more